How to Install Toyota wish rear Brake light sticker
Step 1: Cover 1/3 of a small basin with water and tear off the bottom paper. (You can also spray water directly with a water tap.)
The adhesiveness will be temporarily reduced in water, lowering the stickiness. It will become easy to shift the sticker around for good fitting (with 3M quality, do be ensured that the stickiness will not be reduced when its dry)
Step 2: First clean the surface of the lamp, followed by the alcohol wipes provided. The upper part of the film is to be inserted approx 2-3mm around the top area (to ensure light will not be leaked), make sure the left and right is lined up
If the bottom is protruding out, it indicates that the upper edge is not inserted enough, you can tear off and soak in water, and repeat the above steps to find the best position
Step 3: Push the water out starting from the center to the sides with your fingers (from center out will help reduce wrinkles) and firmly press.
Step 4: Dry area with a quality drying cloth
Do not wash the car (try your best not to kena rain also) within the next 24 hours.
images of sticker